This board is designed to mount on the back of a standard LCD character display such as this one It has an ATMega8 microcontroller (should be compatible with larger ATMega 48/88 etc too).

'Design Notes

The board should mount right on the back of the LCD with 1:1 connections.

The LCD wiring is 4-bit only and a little funny due to the desire to keep the ADC inputs of the AVR available. It will require bit-shifting by 2 bits.

The programming connector (J1) is compatible with the TuxGraphics? programmer.

The board could in principle run on either 3.3V or 5V -- make sure your AVR and LCD are the same voltage!

X1, C1, C2 can be omitted if the AVR is run on its RC oscillator.

J3 has access to all the spare I/Os including 4 ADC channels and the I2C bus.

Last modified 10 years ago Last modified on Nov 8, 2013, 10:17:54 AM